Mobile DVR - Installation Manual
25/47
2. When you open the case, you will find the empty slot to install extra HDD Rack frame or CD Rom. The empty slot is located in different
position.
3. Right above or below of CD Rom, you will find an empty slot to install HDD rack frame. You will have to install the rack frame in that
position. You need to adjust the jumper setting for Rack frame as well as installed CD Rom. The CD Rom that was already installed in PC
should be set as MASTER mode. And you need to set it as SLAVE mode and set MASTER mode for the rack frame. Take off the 40-Pin and
power cable of CD Rom and change the jumper mode. The below picture is where you set jumper mode.
4. When you set the jumper mode for CD Rom (SLAVE MODE) and Rack Frame (MASTER MODE), you need to insert the rack frame as
below picture. Ever if you change the jumper mode, you can use the CD Rom just like you used to.
5. Connect the 40-Pin Cable and power cable as shown on below picture. Check the jumper mode once again.
6. Tighten two screws each on both sides to secure the rack frame.
