LDC-3926339
37
C H A P T E R
4
C
OMMAND
R
EFERENCE
This chapter is a guide to all of the commands for the LDC-3926339 6-Amp
module. It contains an overview of the remote commands used by the module,
shown in Table 4.1, as well as detailed command descriptions, listed in
alphabetical order.
GPIB Commands
Table 4.1
Command Summary
NAME
PARAMETERS
FUNCTION
*CAL?
none
Used for the A/D calibration procedure.
*CLS
1
Resets the Standard Event Register, Status Byte and Error
Queue to zero.
*ESE
1
Used to load the Standard Event Status Enable register.
*ESE?
none
Sets the summary bit (bit 5) in the Status Byte.
*ESR?
none
Returns the value of the
Standard Event Register
.
*IDN?
none
Returns the
DEVICE IDENTIFICATION
string.
LASER:BIAS
1
Enables or disables the 5 V reverse photodiode bias.
LASER:BIAS?
NONE
Returns the status of the photodiode bias control.
LASER:CALPD
1
Used to set the CAL PD (monitor responsivity) constant.
LASER:CALPD?
NONE
Returns the CAL PD (monitor responsivity) constant.
LASER:CAL:ABORT
NONE
Aborts a calibration.
LASER:CAL:DEFAULT
NONE
Restores calibration values to their defaults.
LASER:CAL:LDI
NONE
Starts the constant current source calibration mode.
LASER:CAL:LDV
NONE
Starts the voltage measurement calibration mode.
LASER:CAL:MDI
NONE
Starts the monitor photodiode current calibration mode.
LASER:CAL:MEAS
1
Enters a calibration value.
LASER:CAL:STAT?
NONE
Returns a value which represents the calibration status.
LASER:COND?
NONE
Returns the value of the condition register.
LASER:DEC
2
Decreases the set point value by one or more steps with
user-programmable delay between steps.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com