Assemble Hybridization Chambers
Assemble one chamber for every four BeadChips by following the steps in this section.
Figure 7
BeadChip Hybridization Chamber Components
A
Top of BeadChip Hybridization Chamber
B
Hybridization Chamber Gasket
C
Narrower Edges
D
Wider Edges
E
Hybridization Chamber Inserts
F
Barcode Ridges
G
Bottom of BeadChip Hybridization Chamber
H
Humidifying Buffer Reservoirs
1
Place the gasket into the hybridization chamber.
u
Match the wider edge of the hybridization chamber gasket to the barcode-ridge side of the
hybridization chamber.
u
Press down on the edges of the gasket to make sure it is properly seated.
2
Add 400 µl PB2 into each of the eight humidifying buffer reservoirs in the hybridization chamber.
3
Place the hybridization chamber insert into the hybridization chamber. Position the barcode ridges on the
hybridization chamber insert over the barcode ridges on the hybridization chamber.
Document # 11322427 v03
For Research Use Only. Not for use in diagnostic procedures.
48
Infinium HD Super Assay Reference Guide