- 33 -
S-2018
REV. D
12.
Install the back plate included in the Alkaline Battery Kit by aligning the cover hinge to the hinge pin of the
blower. Ensure that you do not pinch the battery leads or fabric loop when closing the battery pack.
13.
Ensure you hear an audible click when the battery pack latch locks into place.
14.
The blower may now be operated normally, and should provide approximately 8 hours of battery life.
15.
When the low voltage alarm is heard, immediately stop operation of the blower and replace the batteries
with a new set of five Duracell D-cell batteries.
REMOVING THE ALKALINE BATTERY ADAPTOR (P/N S-4013)
1.
Be sure to disconnect the
battery connector and use
the fabric pull strap to
remove the Alkaline Battery
Pack from the blower
Velcro hook before
removing the batteries.
2.
After removing the Alkaline Battery Pack carefully take
out each individual cell, one at a time and set aside for
disposal. Replace with new cells as shown in Step 8
above, Installing the Alkaline Battery Adaptor.
Summary of Contents for S-5000 Series
Page 40: ... 39 S 2018 REV D ...
