- 18 -
S-2018
REV. D
PREPARATION FOR USE (USING BACKPACK ASSEMBLY)
1. Open the blower compartment using the zipper
(see picture to the right).
2.
If using a rechargeable battery pack, remove the battery
charger from the backpack. To charge the PAPR:
• Make sure that the battery pack is assembled to the blower unit
at all times. The battery pack should be separated from the
blower only for battery pack replacement.
• Plug the battery charger to the socket at the back of the PAPR.
• Connect the battery charger to an electrical outlet. A solid green
LED light indicates that the charger is operating properly. When
plugged into the battery the charger LED will turn solid red after
a short time, indicating that charging is underway.
• Charge the battery for approximately 5
hours.
• While the battery is charging, the red LED
on the battery charger will be continuous.
•
The charger LED may flash green when
charging is complete. The charger will then
be in a “trickle charge” mode.
Occasionally, the charger may indicate a
solid green light following a full charge
cycle, which is also considered normal.
• Charging is also possible when the blower
is attached to the backpack, as
demonstrated.
Blower
compartment
zipper
Summary of Contents for S-5000 Series
Page 40: ... 39 S 2018 REV D ...
