6
Ikusi Flow guide
2.3 Installation environment recommendations
Do not plug in the headend in moist rooms.
Never operate the headend immediately after moving it from a cold location to a hot location. When the device is exposed to
such a change in temperature, moisture may condense on the crucial internal parts.
The device must have sufficient ventilation and may not be covered.
Protect the device against direct sunlight, heat, intense temperature fluctuations and moisture. Do not place the device in
the vicinity of heatersor air conditioners.
Do not allow liquids to enter into the device. Turn off the device and disconnect it from the main supply if liquids or foreign
substances end up inside the device.
If the device gets too hot or emits smoke, shut it down immediately and unplug the power cable. Arrange for your device to
be investigated by a technical service centre.
Under the following conditions, a layer of moisture can appear inside the device which can lead to malfunctions:
• if the device is moved from a cold to a warm area.
• after a cold room is heated.
• when this device is placed in a damp room.
The device should not be used in a very dusty or saline environment. Dust or salt particles and other foreign objects may
damage the device.
Do not expose the device to extreme vibrations. It may damage the internal components.
3. BASIC CONFIGURATION
3.1 Connection to the headend
Ikusi Flow is configured through a web page generated by the own headend. To access to that web, you must connect to the
headend via WiFi or via Ethernet cable.
- WiFi option
Connect your terminal (tablet, pc,...) to the Ikusi Flow WiFi network. To do this, choose, among the available WiFi networks,
the one named “IKUSI_FLOW_10_0_0_1_XXXX” (where “XXXX” are the last digits of the FLOW HUB MAC address).
Open your browser and go to 10.0.0.1 address.
- Ethernet cable option
Connect your terminal (for example, your pc) to the configuration port of the FLOW HUB module, identified as
, through
an Ethernet cable.
Configure your terminal to be in the same network than the FLOW HUB module (by default, the FLOW HUB module is
192.168.1.100 IP address). To do this, edit the data related with the IP address of your terminal, for example, with the
following information:
. IP address: 192.168.1.2
. Subnet mask: 255.255.255.0
. Default gateway: 192.168.1.1
Open your browser and go to 192.168.1.100 address
