24
Ikusi Flow guide
This tab shows a list with all the services that are going to be conveyed over RF with an LCN/VCN that has been assigned
automatically. The LCN/VCN value corresponds with the LCN parameter in the case DVB signalling was used or with the
minor_channel_number (VCN) parameter in the case ATSC signalling was used. The user could perform the following
adjustments over the channel list:
INITIAL LCN/VCN: the headend assigns LCN/VCN values automatically starting from 1. If this range was not the proper
one (because it is already in use or because it has been reserved by the network manager for other purposes), you must
change the initial LCN/VCN and push OK button.
LANGUAGES: the headend has two working modes, separated languages or combined languages. When separated
languages mode is selected, in the case a multi-language service, one service will be generated for each language. The
separation is done at logical level, i.e., the used bandwidth is the same as the used with a single service conveying all
the languages; however the TV is detecting several independent services. Therefore, the final user can select the desired
language simply changing the channel. When combined languages mode is selected, a single service will all the languages
will be generated.
LCN/VCN: you will be able to edit the LCN/VCN value suggested automatically by the headend, individually. To do that, click
over
, button and configure the desired LCN/VCN.
SERVICE NAME TO SHOW: you can change the service name that will be shown in the TV. To do that, edit the name
suggested by the headend pushing
button.
LANGUAGE: you can delete the audio channels (languages) of a particular service that you don’t want to transmit. To do that,
click over the audio channel, and it will become red, indicating that it has been deleted.
CAM: the headend automatically decides which CAM will decrypt a particular service. The user can cancel this selection,
and choose manually the proper CAM, among the list of the CAMs that are inserted in the headend.
SERVICE REMOVAL: if you want to fully remove a service from the RF channel line-up, push
button corresponding to that
service.
After doing all the required adjustments over the IP and RF channel line-ups, push button to apply the configuration to
the headend. After a while, the configuration will have been applied. the wizard will close, and the “Home” screen will appear
again.
