Process and dialogue module ecomatDisplay CR1058, CR1059
18
5.4 General wiring information
Wiring of the connectors
1
2
3
1: Supply, inputs/outputs
(CR1059 only), video
(CR1059 only), audio, CAN,
ifm (CR1059 only)
, service
2: USB0
3: ETH0
Connector (back of the device)
NOTE!
Wrong connection may cause damage to the device�
►
Observe the safety instructions�
NOTE!
The short-circuit/reverse polarity protection of the device applies to
the operating voltage connections � A short circuit between operating
voltage VBB
X
and USB / audio / video may cause damage to the
device�
►
Lay supply and signal cables away from the device using the shortest possible
route�
►
All connected cables must be provided with a strain relief�
►
Provide all outgoing cables with a strain relief 200 mm behind the cable entry�
Maximum cable lengths:
● USB ≤ 1.8 m
● Ethernet ≤ 25 m
● video ≤ 30 m
● audio ≤ 30 m
Minimum operating quality audio / video: There may be interference to audio/
video circuits close to strong HF sources� This can result in audible and visible
distortion�