IEI Technology TANK-870AI SERIES, User Manual

Page: 34 / 137

TANK-870AI Embedded System
Page 20
3.1 Installation Precautions
During installation, be aware of the precautions below:

Read the user manual : The user manual provides a complete description of
the TANK-870AI series, installation instructions and configuration options.

DANGER! Disconnect Power : Power to the TANK-870AI series must be
disconnected during the installation process, or before any attempt is made to
access the rear panel. Electric shock and personal injury might occur if the
rear panel of the TANK-870AI series is opened while the power cord is still
connected to an electrical outlet.

Qualified Personnel : The TANK-870AI series must be installed and operated
only by trained and qualified personnel. Maintenance, upgrades, or repairs
may only be carried out by qualified personnel who are familiar with the
associated dangers.

Air Circulation : Make sure there is sufficient air circulation when installing the
TANK-870AI series. The TANK-870AI series’s cooling vents must not be
obstructed by any objects. Blocking the vents can cause overheating of the
TANK-870AI series. Leave at least 5 cm of clearance around the TANK-870AI
series to prevent overheating.

Grounding : The TANK-870AI series should be properly grounded. The
voltage feeds must not be overloaded. Adjust the cabling and provide external
overcharge protection per the electrical values indicated on the label attached
to the back of the TANK-870AI series.
3.2 Hard Disk Drive (HDD) Installation
To install the hard drive, please follow the steps below:
Step 1: Loosen the two thumbscrews on the front panel, slide the cover outward, and
then lift the cover up gently ( Figure 3-1 ).