IEI Technology KINO-9652, User Manual, Page: 102 / 269

KINO-9652 Mini-ITX SBC
Page 80
5.4 Jumper Settings
NOTE:
A jumper is a metal bridge used to close an
electrical circuit. It consists of two or three metal
pins and a small metal clip (often protected by a
plastic cover) that slides over the pins to connect
them. To CLOSE/SHORT a jumper means
connecting the pins of the jumper with the plastic
clip and to OPEN a jumper means removing the
plastic clip from a jumper.
Figure 5-7: Jumper Locations
Before the KINO-9652 is installed in the system, the jumpers must be set in accordance
with the desired configuration. The jumpers on the KINO-9652 are listed in Table 5-1 .
Description Label Type
Clear CMOS J_CMOS1 3-pin header
COM 4 function selection JP5 6-pn header
COM port RI and voltage selection JP1, JP2 10-pin header
LVDS LCD voltage selection J_VLVDS1 3-pin header
LVDS LCD resolution selection JP3 8-pin header
Table 5-1: Jumpers
5.4.1 Clear CMOS Jumper
Jumper Label: J_COMS1
Jumper Type: 3-pin header
Jumper Settings: See Table 5-2