IEI Technology IOWA-MARK, User Manual

Page: 143 / 232

IOWA-MARK Half-size CPU Card
Page 123
Auto (D
EFAULT
) System automatically sets the AGP bus signal strength
Manual The AGP bus signal strength is set manually in the next
BIOS configuration option
AGP Driving Value [DA]
The AGP Driving Value option can only be configured if the AGP Driving Control option
is set to manual. Use the AGP Driving Value option to manually set the strength of the
AGP bus signal. If this option is selected, a hexadecimal number must be entered. The
higher the hexadecimal number is, the stronger the AGP bus transmission signal is. The
maximum and minimum hexadecimal numbers are shown below:
MIN : 0000
MAX : 00FF
Select Display Device [Auto]
Use the Select Display Device option to specify the display used by the system.
Auto (D
EFAULT
) The system automatically detects the display
devices connected to the system
CRT
A CRT screen is connected to the system
LCD An LCD display is connected to the system
CRT + LCD A CRT display and an LCD display are connected to
the system simultaneously. This option should be
set for dual independent display mode.
Panel Type [1024 x 768 TFT]
Use the Panel Type option to specify the type of panel connected to the system.
Configuration options are below:
640 x 480 TFT