IEI Technology AFL-xxA-N270 series, User Manual, Page: 53 / 171

AFL-xxA-N270 Series Panel PC
Page 38
4.9.3 Clear CMOS Jumper
Jumper Label:
J_CMOS1
Jumper Type: 2-pin header
Jumper Settings:
See
Table 4-3
Jumper Location: See
Figure 4-7
If the AFL-xxA-N270 fails to boot due to improper BIOS settings, the clear CMOS jumper
clears the CMOS data and resets the system BIOS information. To do this, use the jumper
cap to close the pins for a few seconds then remove the jumper clip.
If the “CMOS Settings Wrong” message is displayed during the boot up process, the fault
may be corrected by pressing the F1 to enter the CMOS Setup menu. Do one of the
following:
Enter the correct CMOS setting
Load Optimal Defaults
Load Failsafe Defaults.
After having done one of the above, save the changes and exit the CMOS Setup menu.
The clear CMOS jumper settings are shown in
Table 4-3
.
Clear CMOS Description
Short 1 - 2 Keep CMOS Setup Default
Short 2 - 3 Clear CMOS Setup
Table 4-3: Clear CMOS Jumper Settings
The location of the clear CMOS jumper is shown in
Figure 4-7
below.