(C) IDM ENERGIESYSTEME GMBH
Installation instructions iPump A 3-11
5
general information
1.5. Sound emission
The iPump A 3-11 outdoor unit is very quiet in opera-
tion thanks to the design. It is however important that
the site of the heater is situated as far as possible
from noise-sensitive living areas. This also applies to
refrigerant connection lines between the outside- and
the indoor unit.
Also the boiler room where the indoor unit of the
iPump A 3-11 is installed should be placed outside of
the noise sensitive living area. The boiler room should
be furnished with a good lockable door.
1.6. Ice-covering outdoor unit
Depending on the weather and outdoor humidity, it
may happen that there will be formed an icy covering
on the protective grids of the heat pump. This effect
is common occuring in nature. This covering must
be removed by the heat pump operator during this
weather periods.
1.7. Installing additional components
The installation of additional components which have
not been tested with the equipment may impair its
function. No liability is accepted and your guarantee
is void in the event of damage caused for this reason.
1.8. Constr uction dr ying and screed heating
The heat pump is not designed for the increased heat
requirements when drying out construction work or
heating plaster or screed. This must be covered by
equipment to be provided by the customer if required.
1.9. Cleaning
If necessary, the internal and the outdoor unit of the
iPump A 3-11 can be cleaned with a damp cloth. The
use of cleaning agents is not recommended.
1.10. Ser vicing and maintenance
Regular maintenance control and servicing of all
system components guarantee its safe and econo-
mical operation in the long term. To achieve this, we
recommend a maintenance contract with the relevant
customer service company.
Only original spare parts which meet the requirements
of iDM may be used!
1.11. Ser vice
For technical information please contact your relevant
iDM customer service department.
1.12. Warranty and guarantee
Warranty and guarantee conditions are included
in the purchased documents. For questions please
contact your relevant customer service department.
1.13. Disposal
Heatpumps are electrical equipment made from
high valuable materials, which are not allowed to be
disposed like normal household garbage, but have to
be disposed professional and proper according the
regulations of the local authorities.
A non-proper disposal can cause, apart from sanc-
tions for the violator, environmental damages and
harm for your health.
This device is characterized according to the euro-
pean directive 2012/19/EU on waste electrical and
electronic equipment (Waste electrical and electronic
equipment - WEEE). The guideline provides the
framework for an EU-wide return and recycling of old
equipment.
Dispose the device properly and do not damage the
pipes of the refrigerant circuit.
