19
72-910-24 Revision H
Password Setting
From the Password setting you select the user password that will be required to gain access to the
Configuration and Settings menus. Once the password is set to anything other than 0000 (4-zeros) the
password feature is enabled. To disable password protection, return the password to 0000 (4-zeros).
Password
– Set the user password.
Once the password is set the controller will require a password to access any menus. If the
password is lost or unknown, you will have to call technical service to gain access to the
controller menus. Please have the controller in front of you when you place the call.
Troubleshoot Screen
From the Troubleshoot Screen you can view the MicroVision control inputs in real-time. This is a great
tool for checking the correct operation of sensors that are attached to the controller.
Input 1 to 5–
(J4 pins 1-2). Indicates current state closed, or open.
Wk –
Revolving week number between one and four. This is used in the 28-day timer
Days/Weeks settings.
Cnd –
Displays the current conductivity reading in real time
Tmp –
Displays the current temperature in degrees C
Day –
Day of week. This is used in the 28-day timer Days/Weeks settings.
Sec -
Current clock seconds.
While this screen is displaying information, the controller is still functioning normally, and
relay outputs may energize without warning due to changing signal inputs.
Software Version
From the Software Version screen, you can view the current software that is running in the Microvision
controller.
Software Version
– This screen displays the current software version.
Home Screen
Configure
Troubleshoot
Ip 1: Open Ip 2: Open
Ip 3: Open Ip 4: Open
Ip 5: Open
Cnd: 03500 Tmp: 65.3 C
Wk: 2 Day:Mon Sec:23
Back | Back
Home Screen
Configure
Software Ver
Software
Version
01.00
Back |Back
Home Screen
Configure
Password
Change
Password
0000
Cancel |Enter
