14
72-910-24 Revision H
Menu Navigation
MicroVision uses four front panel buttons to navigate through the different menus. Use these buttons
to move up and down within a list of options or move right and left to enter or change parameter
values. In some cases, the Microvision display will prompt you to press the different buttons to assist
you in selecting or changing data.
Some menus may display highlighted menu options or a checkmark (
) next to a menu option. The
highlighted menu option is used to indicate that another menu will be displayed if this option is chosen.
The checkmark indicates that a particular control mode has been selected.
Home screen
This screen is displayed during normal operation when there are no alarm conditions on the
Microvision. If an alarm condition occurs an alarm message will flash on the screen. The four LED’s to
the right of the display will also flash indicating an alarm has occurred.
The MicroVision will return to this home screen if no buttons are pressed for five minutes after entering
a menu.
Main Menu
The Main menu is the starting point for all subsequent menus.
Configure
– This menu allows you to set the time and date, display contrast, water meter, etc.
Settings
– This menu allows you to set the conductivity, and chemical feed modes.
Status Screen
Home Screen
Output hours
Bdn: 123.4 Tmr 1: 123.4
Tmr 2: 123.4 Tmr 3: 123.4
Tmr 4 : 0.2
Last Error: Cond Low
Back | Reset
Home Screen
Configure
Settings
Back | Select
Date/Time
HOA Outputs
Inputs
Back | Select
Auto
On 5 Min
Off
Back | Select
01/23/09 | 11:42a
Bd: Timed
2900 uS/cm
Status | Menu
