Annex 1 : Finger Placement Recommendations
2019_200000XXXX-V0
IDEMIA
D
OCUMENT
-
R
EPRODUCTION AND
D
ISCLOSURE
P
ROHIBITED
47
December 2018
Ethernet connection
Ethernet interface can be used to power the MorphoAccess® VP MD terminal through
POE (Power Over Ethernet - IEEE802.3af or IEEE802.3at type 1 mode). According to the
POE standard two modes are available: power on data pins and power on dedicated
pins.
Use either one of these modes depending on POE implementation on your local
Ethernet network.
Wi-Fi™ dongle must not be used with POE power supply. The POE doesn’t
provide enough power for both the terminal and the Wi-Fi USB dongle.
Ethernet cable shall be shielded
Default Ethernet configuration
By default, MorphoAccess® VP MD terminal is configured in Static mode
IP address Mode
Parameter
Factory value
Static
Terminal IP address 192.168.1.10
Gateway IP address 192.168.1.254
Sub network mask
255.255.254.0
Host name
MA-VP
Connecting MorphoAccess® VP MD terminal with default Ethernet
configuration
Administrator must change the default Ethernet configuration before deploying
terminal on site. This can be achieved by several ways as mention below.
MBTB > Quick Configuration > Communication Configuration > IPv4 Address
Settings
MBTB > USB Script > Set IP configuration
Webserver > Terminal Settings > Communication > IPv4 Network
Prior to connecting through MBTB or Webserver, please check if terminal is accessible
from Host system/PC or not. To access terminal which is having default network
parameter, the administrator may need to modify the network parameters of the Host
PC.
Please refer to following example to connect terminal which is having default network
parameter.
