IDEC SE2L-H05LPC, User Manual

Page: 123 / 152

SE2L User’s Manual (SE9Z-B1865)
122
Figure 7-59 SD Card selection screen
Figure 7-60 Transmission succeeded
7.23 SE2L configuration through SD card
Configuration from the SD card is possible for the devices whose serial number and password are
registered in the SD card. Devices whose serial number or password does not match cannot be configured .
 Enter the SD card containing the setting file into the SE2L’s SD card slot. Seven segment display will
show the status “F2” to indicate the SD card detection.
 If the serial number and password of the device matches with the registered serial number and password
in the file, configuration will start. Seven segment display will show the status “F3”.
 At the end of the configuration seven segment display will show the status “F4”. Remove the SD card
from its slot to finish the configuration.
 Seven segment display will show the status “F5” briefly and device will restart showing the status “00”.
 On successful completion area number will be visible on the display.
 Do not switch OFF the SE2L or remove the SD card during the configuration. It
may lead to configuration failure.
 Do not connect SE2L with the SLS Project Designer by USB cable during the
configuration from the SD card.
 Do not switch off the SE2L without removing the SD card when the display is
showing the status “F4”. Configuration will be incomplete in such case.