IDEC SE2L-H05LPC, User Manual, Page: 41 / 152

SE2L User’s Manual (SE9Z-B1865)
40
Table 3-4 Response time of SE2L
Response time (ms)
60 90 120 150 180 210 240 270
OFF
(ON -> OFF)
300 330 360 390 420 450 480 510
Response time (ms)
270
ON
(OFF -> ON)
300 330 360 390 420 450 480 510
* Default value
* Minimum configurable response time in Master/Slave mode is 120ms for OFF and 300ms for ON.
3.13 Other outputs
SE2L consist of 6 non-safety outputs, WARNING1, WARNING2, MUT_OUT1, MUT_OUT2 and
RES_REQ1 and RES_REQ2. WARNING1/OSSD3, WARNING2/OSSD4, RES_REQ1/ MUT_OUT1 and
RES_REQ2/ MUT_OUT2 are configurable outputs that share the same terminal. When the functions are
selected using SLS Project Designer, outputs are configured automatically.
3.13.1 Warning output 1 (WARNING 1)
This signal will switch to OFF-state when an obstacle is detected in the configured warning zone 1.
3.13.2 Warning output 2 (WARNING 2)
This signal will switch to OFF-state when an obstacle is detected in the configured warning zone 2.
3.13.3 Muting output 1 (MUT_OUT 1)
MUT_OUT1 indicates the muting/override status of the protection zone 1. When the muting function is
activated, MUT_OUT1 will switch to ON-state. At the same time, number 37 is displayed on the 7-segment
LED. This signal should be used to indicate that protection zone 1 is in muting state or override state.
3.13.4 Muting output 2 (MUT_OUT 2)
MUT_OUT2 indicates the muting/override status of the protection zone 2. When the muting function is
activated, MUT_OUT2 will switch to ON-state. At the same time, number 38 is displayed on the 7-segment
LED. This signal should be used to indicate that protection zone 2 is in muting state or override state.
When both protection zone 1 and protection zone 2 are in muting or override state, number 39 is displayed
on the 7-segment LED.