IDEC SE2L-H05LPC, User Manual, Page: 44 / 152

SE2L User’s Manual (SE9Z-B1865)
43
3.15 Ethernet communication
Measurement data of SE2L can be obtained from the Ethernet communication. Water proof Ethernet
connector is located at the back of SE2L. To connect sensor with PC, use an Optional Ethernet cable
(SE9Z-HS2-XCD13).
For the communication specification of SE2L, contact the nearest distributor or sales representative.
3.15.1 Ethernet Setting
● Default setting
Factory default value is shown below.
IP address : 192.168.0.10
Subnet mask : 255.255.255.0
Default gateway : 192.168.0.254
Port number : 10940
● Changing the IP address
IP address can be changed by using SLS Project Designer. Refer to section 7.13 and 7.9.1 for details.
● IP address initialization
Ethernet settings can be set to factory default by using IP initialization switch.
<Initialization steps>
a) Prepare a thin strong pin for IP initialization process. IP initialization switch is located exactly below the
SD card Slot (Refer to figure 3-27)
b) When SE2L is operating in normal state, press and hold the IP initialization switch for more than 3
seconds. After initialization process is complete 7-segment display status changes to “Fb”.
c) Sensor restarts with 7-segment display showing the status “00”.
Figure 3-27 IP initialization switch
IP Initialization switch SD Card Insert Slot