15
Minimiser
-
Installation
INSTALLATION
18 CUTTING THE FLUE
Wall thicknesses of 114 to 600mm
Note.
If the optional standoff bracket kit is used it is essential that
30 mm is added to the measured wall thickness when
marking the flue (to allow for the thickness of the brackets).
1.
Measure and note wall thickness X.
2.
Add 61mm (2
3/8
") to dimension X and, measuring from
the groove, cut the tube.
3.
To ensure the tube is cut square, mark the flue all the
way round.
4.
Cut to length, using the cardboard support aid.
5.
Remove the cardboard support and any burrs.
REAR FLUE OUTLET
19 ASSEMBLING THE FLUE
1.
Using the tube of sealant provided, apply sealant right round
the inside of the flue tube on the turret.
2.
Fit the 'cut to length' flue on to the flue turret.
Note.
Ensure the groove in the flue aligns with the top of the turret
.
3.
Drill a 3.2mm dia. hole through the hole provided in the turret
and through the outer flue duct.
4.
Using the self tapping screw provided, fix the flue assembly
to the turret.
cardboard
support cutting aid
20 MOUNTING THE BOILER
1.
Lift the boiler onto the wall mounting plate, as
shown.
2.
Check the boiler alignment using a spirit level
and adjust as necessary with the jacking
screw.
3.
Align the hole in the jacking plate with the pre-
drilled hole in the wall and fix in position with
the No.10 x 2" screw provided.
Note.
If the front of the boiler is to be flush with the front
of 300mm deep kitchen units then the optional
stand-off bracket kit should be used - refer to the
fitting instructions supplied with the kit.
