Subject to technical changes | Valid as of January 2022
36
TECHNOLOGY
CALEO COLD/NEUTRAL
02
2.6. Installation of the control box
The controller housing (incl. controller and display) is attached to the base of the unit (standard version). In the case of remote re-
frigeration units, the controller is supplied loose and must be professionally installed after unit installation.
Each controller consists of the display (control panel) and the power
electronics (PCB) that is built into the housing of the control box. The
display is connected to the power electronics internally by a cable.
The control panel is removable and can be mounted in the front of
the appliance.
ST200F
ST501
ST200F:
The control panel is connected to the power electronics by default with a CAT5 cable that is up to
1.5 metres long (max 100 metres).
ST501:
The control panel is connected to the power electronics by a maximum 1.5-metre-long cable
(>2 m data transmission faulty).
Possible configurations
Depending on the unit type, different controllers (cooling zone controllers) may be installed. The enclosed operating
manual for the controller must be observed under all circumstances.
The cut-out required for the display is as follows:
•
ST501:
87,5 mm x 56,5 mm
•
ST200F
102,5 mm x 52,5 mm
See Chapter 3.2 for the button assignment
NOTE
NOTE
Summary of Contents for CALEO AIR TOWER
Page 1: ...Operating Manual CALEO COLD NEUTRAL 22A Translation of the original ...
Page 2: ...Subject to technical changes Valid as of January 2022 2 ...
Page 41: ...Subject to technical changes Valid as of January 2022 41 NOTES CALEO COLD NEUTRAL ...
Page 53: ...Subject to technical changes Valid as of January 2022 53 NOTES CALEO COLD NEUTRAL ...
