Subject to technical changes | Valid as of January 2022
34
TECHNOLOGY
CALEO COLD/NEUTRAL
02
2.5.2. Unit installation
If two units have to be installed back-to-back or side-by-side, then they must be secured by the back-wall connector.
The back-wall connector consists of:
Observe the associated installation guide for the „Caleo Island“. The instructions contained in it must be followed. The instructions
can be found on the manufacturer‘s homepage or are available from customer support.
Back-wall connector tab
Connectors (2x)
Connecting screws (2x)
Unit installation for more than 2 units (back-to-back or side-by-side):
Proceed as follows to install the back-wall connector.
1.
Step:
Check whether the units are parallel to each other at the boundaries of the units (back side of the unit).
2.
Step:
Put the back-wall connector tabs on both units as shown (3 holes each).
3.
Step:
Slide the connector into the back-wall connector tab. Do the same on both sides. The holes for the connec-
ting screws must overlap
4.
Step:
Place the connecting screws in the two holes and tighten them. Check the hold of the connection.
5.
Step
: Mount the exhaust air duct cover on the left and right as well as the top exhaust air covers. Check the hold
of the parts. Make sure that the exhaust air duct not covered or dirtied. Air circulation must be ensured for proper
operation of the units.
Make sure that the exhaust air duct not covered or dirtied. Air circulation must be ensured for proper operation of the unit.
NOTE
Summary of Contents for CALEO AIR TOWER
Page 1: ...Operating Manual CALEO COLD NEUTRAL 22A Translation of the original ...
Page 2: ...Subject to technical changes Valid as of January 2022 2 ...
Page 41: ...Subject to technical changes Valid as of January 2022 41 NOTES CALEO COLD NEUTRAL ...
Page 53: ...Subject to technical changes Valid as of January 2022 53 NOTES CALEO COLD NEUTRAL ...
