ID Technology 252, Operator / Technical Manual

Page: 23 / 164

Model 252
Label Printer/Applicator
Operators/Technical Manual
4
6.7 Service Tamp Module
The service tamp module performs exactly like a standard tamp module. The additional
service feature allows the tamp pad and air cylinder/bearing block portion of the tamp
assembly to be rotated in an outward direction. This allows for easier access when
servicing the engine or performing tamp pad change-over operations. Tamp pad
requirements remain the same.
6.8 Tampjet Upgrade
The tampjet upgrade kit converts the tamp pneumatics to add tampjet functionality.
Tampjet adds a blast of compressed air at the end of the tamp stroke to propel the label
from the tamp pad to the product. This is useful for applying labels to delicate products,
fast moving products, or products with slightly irregular surfaces. The tampjet upgrade
kit contains the tampjet valve and all required plumbing and electrical connections.
6.9 Smart Tamp Sensor
With the addition of a smart tamp sensor, tamp type applications can be used with
products that may vary in size. The sensor is mounted just above the tamp pad and
positioned to detect the product to be labeled. During label application, the sensor detects
the product and provides a signal to the electronics module. This signal is used to control
the activation timing of the tamp solenoid valve. This effectively adjusts the stroke
length of the tamp assembly air cylinder to the correct label application position.
Adjustments are provided for fine tuning the actions.
6.10 Tamp Home Sensor
The tamp home sensor is used to signal that the tamp unit has returned to the fully
retracted or “home” position. This signal can be sent to the system status outputs for use
with external printer applicator or other control systems. The only available adjustment
is to the sensitivity of the sensor. See the Component Information section for more
information.
6.11 Swing Tamp Module
Swingarm tamp modules can be used for some applications that require applying labels in
restricted spaces or at odd angles. Several swingarm tamp modules are available and can
be configured to match the Left Hand or Right Hand model 252. They can be mounted to
the baseplate in swing out, swing left, or swing right directions.
The swing left or swing right mounting must match the label feed
direction and will place the adhesive side of the label facing that direction
as well. The swing out direction will result in the adhesive facing to the
front of the Model 252.