ID Technology 252, Operator / Technical Manual

Page: 86 / 164

Model 252
Label Printer/Applicator
Operators/Technical Manual
61
The angle of the tamp pad in the home position should be parallel to the edge of the
faceplate. To adjust the angle, extend the swing arm to the apply position, locate the red
bumper, and loosen the locking nut. Adjust the bumper height until the tamp pad angle is
correct in the home position. It may be helpful to perform this adjustment in conjunction
with the tamp pad height adjustment.
The angle of the tamp pad/paddle should be adjusted for proper application of the label
on the product. Normally, the label should be applied at the same angle as the product.
To adjust the tamp paddle angle, extend the paddle to maximum by hand. Place a
product in position to be labeled. If the angle is incorrect, locate and loosen the lock nut
on the air cylinder rod end clevis. Adjust the rod in or out until the proper angle is
reached and retighten the lock nut. Return all cylinders to the home position.