Model 252
Label Printer/Applicator
Operators/Technical Manual
10
After the “U” arm has been secured to the cabinet, the complete assembly can be
mounted to the upright or other supporting structure.
The “U” arm attaches to the upright using the washer and locking nut supplied with the
upright. To mount the 252E to an upright, support the enclosure, and insert the mounting
stud on the upright into the hole on the “U” arm. Immediately install the washer and
locking nut that came with the stand and tighten until the applicator is secured but still
movable. Adjust the tilt attachment screws and upright stand as needed to position the
applicator correctly and tighten the locking nut until secure.
If the applicator is to be mounted from the top, a second person must be
assisting. One person must support the applicator while the other installs
the washers and locking nut. Injury and/or damage can occur if
installation is attempted alone.
When mounting from the side or bottom, the applicator will suspend itself
from the mounting stud prior to the locking nut being installed. Do not
leave the unit unattended or attempt operation until the locking nut has
been firmly secured.
FLAT
WASHER
LOCK NUT
MOUNTING
STUD
UPRIGHT
STAND
TILT
ADJUSTING
SCREWS
STABILIZER
BLOCK
U-ARM
APPLICATOR AND ENCLOSURE
REMOVED FOR ILLUSTRATION
ALTERNATE ENCLOSURE
MOUNTING POSITION
Summary of Contents for 252
