Time Controller Series User Manual
Section 9: Appendix: SCPI Command Reference
ID QUANTIQUE SA
1227 Geneva
T +41 22 301 83 71
83
Rue Eugène-Marziano 25
Switzerland
F +41 22 301 83 79
9.2.5
Output (OUTPut)
Output block
OUTP#
(# = 1...4)
Command tree
Input
Output
Description
OUTPut#
Selects output number #
:ENABle
{ON|OFF}
Enables or disables the
output
:ENABle?
{ON|OFF}
:MODE
{NIM|TTL}
Sets output level to NIM or
TTL
:MODE?
{NIM|TTL}
:LINK
address
Selects the block from
which to take the
timestamp stream
:LINK?
address
:LINK:ADDResses?
list of
addresses
Returns the valid addresses
to which this block can be
connected.
:PULSE
{ON|OFF}
Enables the pulse mode of
the output
:PULSE?
{ON|OFF}
:PULSE:WIDTH
Pulse width in ps
Pulse width in ps
:PULSE:WIDTH?
Pulse width in
ps
:DELAY
delay in ps
Set delay in ps
:DELAY?
delay in ps
:STATe?
State of the block
Additional information about the Pulse function:
•
The output generates a pulse of the chosen width every time an event (rising edge) arrives
at the in-port of the output block