![background image](http://html1.mh-extra.com/html/ics/multipanel-2025/multipanel-2025_manual_3540033015.webp)
ENG
Channels
15
Configuring measurement channels C1 and C2
If you are using a sensor without ISDS, you have to
configure a channel. You need a corresponding pa-
rameter for the sensor. They are on the sensor or in
the sensor data sheet.
The measuring instrument only detects ISDS sensors
when the measuring instrument is being switched on.
You can configure an ISDS sensor manually if you do
not connect it until the measuring instrument is
switched on.
You must define the following parameters during the
configuration:
•
C1/2
: Measurement variables and unit of meas-
urement
•
Signal
: Signal type and range, if applicable
•
Range
: Measurement series or calibration value
Measurement variables and units of measurement
You can configure sensors for the following measure-
ment variables and units of measurement.
Signal type, signal range and Range
You can configure sensors for various signal types
and signal ranges. Make sure that the signal type
matches the selected measurement variable.
The range can have the following meaning depending
on the signal type:
•
Measuring range
•
Calibration value
The following table shows signal types and the corre-
sponding meaning of the range:
Measuring range
The measurement series is specified for the signal
range. You must enter the upper and lower limit.
Every limit value is a number and is entered as five
characters. The first character can be a minus sign.
Digits or periods (correspond to commas) are also
characters.
Examples for limit values:
• -9999
• -2.50
• 60.00
• 99999
Measurement variable
(measurand)
Unit of
measurement
Pressure
p
[mbar]
p
[bar]
p
[psi]
p
[Pa]
Temperature
T
[°C]
T
[°F]
Rate of flow
Q
[l/min]
Q
[GPM]
Rotation
n
[rpm]
n
[rpm]
Frequency
f
[Hz]
Current
U
[mV]
U
[V]
Current strength
I
[mA]
I
[A]
Force
F
[kN]
Torque
M
[Nm]
Course
s
[mm]
Speed
v
[mm/s]
Angular speed
v
[°/s]
Ground
m
[to]
m
[kg]
Volume
V
[l]
V
[ccm]
Signal type
Display
Range
Current
0 ... 20mA
Measuring range
4 ... 20mA
Current
0 ... 10V
Measuring range
2 ... 10V
Frequency
FRQ
Calibration value
±FRQ
Counter
CNT
Calibration value
±CNT
Measurement variable
(measurand)
Unit of
measurement
Summary of Contents for MultiPanel 2025
Page 25: ...ENG Technical data 25 ...
Page 26: ...Technical data 26 Operating Instructions Version 1 0 ...
Page 27: ...ENG Technical data 27 ...
Page 28: ......