41
© 2011 ICS- Blount Inc Specifications and pricing are subject to change without notice. P/N 525747 REV12Sep2012
680GC SERVICE MANUAL
10. CYLINDER COVER
10.7
Remove stop switch leads.
10.8
Inspect cylinder cover for damage.
A. Replace if necessary.
10.9
Check cylinder cover water seal and filter
cover gasket are in place and in good
condition.
A. Replace if necessary.
10.10
Reassemble stop switch leads.
10.11
Make sure carburetor screw boot is in place.
10.12
Lubricate compensating tube and fuel tank
breather tube with soapy water, guide through
cylinder cover (install compensating tube
first).
NOTE:
Be careful as to not pull tubes away from
their point of connection. Approximately 3/4"
2 cm) of tube should protrude from cylinder
cover.
screw boot
