© 2007 ICS, Blount Inc.
F/N 518537 Oct 07
TITLE
603GC SERVICE MANUAL
70
22
This section covers carburetor tuning. Included in this section are basic settings,
idle speed adjustment, and complete adjustment.
The carburetor on a new saw is set at the factory for optimal performance and
compliance to EPA Phase 1 emmissions standards. However, minor adjustments
may be required in certain conditions, such as high elevation. A replacement
carburetor is not set correctly from the factory. Use the tuning instructions in this
manual to adjust carburetor to factory-recommended settings. (DO NOT adjust
the carburetor for maximum rpm. Adjusting the carburetor for maximum rpm will
cause engine damage).
Always set the carburetor jets to factory settings
when replacement or complete rebuild becomes necessary.
NOTES:
• These cut-off saws are equipped with an electronic speed limiter, as part of
the ignition system. This will prevent the saw from going above 12,500 rpm.
Attempting to set the carburetor mixture to increase the speed or power beyond
this limit may seriously damage the engine.
• Always check the air filter, pre filter, fuel filter, and spark plug before making
carburetor tunings and clean or replace if necessary
22. CARBURETOR TUNING
Summary of Contents for 603GC
Page 1: ...F N 518537 Oct 07 2007 ICS Blount Inc 603GC SERVICE MANUAL...
Page 2: ......
Page 84: ......
Page 85: ......