http://www.icpdas.com
I8094A &I8094HGetting Started manual
Ver 1.3-- 13
2 HARDWARE INSTALLATION
2.1 i8094A/i8094H Check Package & Installation
2.1.1 Check Package
i8094A/i8094H
is a 4-axes stepping/servo motor control module; you will need
a WinCON-8000 series PAC to serve as the controller.
You will need:
W-8x31-GM1 PAC controller
You will also need the following items to implement installation of i8094A/i8094H
modules:
i8094A/i8094H
4-axes motion control module
DN-8468 series
i8094A/i8094H interface board
CA-SCSI15
68-pin
SCSI-II cable, length: 1.5 m
2.1.2 i8094A/i8094H Installation
Before Installation
1. You will need a ICP DAS (W-8000series) PAC controller with I/O expansion slot
(currently we offer a variety of 3- or 7- slot)
2. Turn off the power.
Modules Installation & Wiring
1. Position the i8094/i8094F module over the I/O Expansion Slot, aligning the
module card with the groove at the side of the Expansion Slot.
2. Insert the module into the I/O Expansion Slot, glide the module card along the
groove; press down the module until it is completely seated on the Expansion
Slot.
3. Secure the module by push down the “LOCK” latch.
4. Connect the i8094/i8094F with DN-8468G by a CA-SCSI15 cable, as the below
figure:
