ICONE X5 iDESERT, Instruction Manual For Use

Page: 74 / 92

7. Charging and protecting the
battery
Use the charger that corresponds to your e-Bike (never use a charger of a different model).
Before recharging, set the switch to OFF and remove the key. Keep the charger in a dry and
ventilated place when not in use.
The charger is designed for indoor use. Keep the charger away from water to avoid short
circuit. Do not use in humid and flammable environments. Do not remove the connector by
pulling on the cable, always disconnect the charger from its metal body.
Connect the output plug of the charger to the battery socket correctly, then insert the input plug
into the wall socket.
When the light changes from Red to Green it means that the battery is fully charged. Usually it
takes 4-6 hours to recharge the battery. However, it is advisable to recharge the battery for an
additional 2 hours to safeguard the life of the battery.
Do not recharge the battery for more than 10 hours to avoid overcharging and damaging the
battery. After the light turns green the charger remains in maintenance mode. If you plan to be
away from home for a long time, disconnect the charger to avoid overheating.
The charger will become hot while charging, so keep it away from heat sources. Always keep
the charger clean and dry. The charger contains high voltage electronic elements, so please
do not disassemble the charger yourself.
After charging, first remove the plug from the electrical socket and then from the battery of the
e-Bike. Do not leave the connector inserted in the battery and in the power socket for a long
time, it could damage the battery and cause a fire.
When charging, keep out of the reach of children. Do not place anything above the charger
during use, do not allow any liquid or metal to enter the charger.