Switch
External
headset
[SW]
VE-PG2
192.168.0.2
[IN]
[OUT]
Call destination number: 4
Transceiver 1
[TRX1]
Connect to the transceiver 1’s speaker jack.
NOTE:
First, connect the transceiver
to the VE-PG2 using the optional
OPC-2073. Then turn ON the power
to the transceiver and the VE-PG2.
[TRX1]
CAUTION:
To connect the transceivers or repeaters, use only the following cables:
OPC-2073 (For the transceivers) or OPC-2074 (For the repeaters).
Connect the specified cables to [TRX1], [TRX2] or [TRX3] only.
Using another cable, like an Ethernet cable may damage the VE-PG2,
transceivers or repeaters.
Transceiver 2
Other transceivers
Turn the transceivers’ power ON,
and then set the Transceiver 1’s
volume control to the 12 o’clock
position.
38
SELECTIVE CALL MODE APPLICATION
2
■
Using with an emergency device
S����� 10 O����������
• M�k��g �� ������g����� b��������� f��� ��h�� ��x�������l ������g����� ���v����.
q
Turn ON the power to transceiver 2 and set its operating channel to the same as
transceiver 1.
w
When a signal from the emergency device’s switch is sent to the VE-PG2 for
more than 0.1 second, the emergency broadcast from the emergency device
is then sent through the VE-PG2 to the external Public Address device and to
transceiver 1.
• Any transceiver that is set to the same channel as Transceiver 1 will also receive the
broadcast through transceiver 1.
e
The VE-PG2 sends the emergency broadcast continuously until the emergency
device’s switch turns OFF.
• The kind of emergency broadcast that is sent depends of the type of external emergency
device.
[NOTE]
If you want to make an announcement to the external Public Emergency Service
using transceiver 2, follow the steps outlined below:
q
Hold down transceiver 2’s [PTT], and push [4] and [#] to transmit DTMF signals.
w
When the VE-PG2 receives the DTMF signals, it will send a �Broadcast start
sound�� to the external amplifier.
e
Hold down transceiver 2’s [PTT] and talk into the microphone to make the
announcement.
r
When you finish, hold down transceiver 2’s [PTT], and push [#] to transmit a
DTMF signal (or send no sound for 15 seconds) to disconnect transceiver 2 from
the VE-PG2, which will disconnect the communication route.
