6
BRIDGE MODE APPLICATION
1
In the Unicast mode, the VE-PG2 specifies a port number, IP address and calls a
specified transceiver that is connected to the VE-PG2.
The following descriptions are based on the step by step example shown below.
Example: Operating VE-PG2 in local area network.
Transceiver B3
[TRX2]
Transceiver A2
[TRX1]
(Port number: 21500)
HUB
Transceiver A1
[TRX1]
[Area A]
[LAN]
192.168.0.2
VE-PG2
1
2
3
4
5
[Area B]
Transceiver B2
[TRX1]
(Port number: 21500)
[TRX1]
Transceiver B1
[LAN]
192.168.0.3
VE-PG2
If you connect the VE-PG2 to a global network (internet),
you can communicate anywhere through the IP network
without using hub.
CAUTION:
To connect the transceivers or repeaters, use only the following cables:
OPC-2073 (For the transceivers) or OPC-2074 (For the repeaters).
Connect the specified cables to [TRX1], [TRX2] or [TRX3] only.
Using another cable, like an Ethernet cable may damage the VE-PG2,
transceivers or repeaters.
CAUTION:
To connect the transceivers or repeaters, use only the following cables:
OPC-2073 (For the transceivers) or OPC-2074 (For the repeaters).
Connect the specified cables to [TRX1], [TRX2] or [TRX3] only.
Using another cable, like an Ethernet cable may damage the VE-PG2,
transceivers or repeaters.
Connect to the transceiver A2’s speaker jack.
Connect to the transceiver B2’s speaker jack.
NOTE:
First, connect the transceiver
to the VE-PG2 using the optional
OPC-2073. Then turn ON the power
to the transceiver and the VE-PG2.
NOTE:
First, connect the transceiver
to the VE-PG2 using the optional
OPC-2073. Then turn ON the power
to the transceiver and the VE-PG2.
Turn the transceivers’ power ON, and
then set the Transceiver A2’s volume
control to the 12 o’clock position.
Turn the transceivers’ power ON, and
then set the Transceiver B2’s volume
control to the 12 o’clock position.
■
U������� ����� �����������
U������� ����� �����������
