Icom IC-V80, Instruction Manual

Page: 53 / 59

47
Previous view
If your transceiver seems to be malfunctioning, please check the followings before sending it to the service center.
PROBLEM POSSIBLE CAUSE SOLUTION REF.
No power comes on. • The battery is exhausted.
• The battery polarity is reversed.
• Bad connection of a battery pack
or case.
• Charge the battery pack, or replace the
batteries.
• Check the battery polarity.
• Clean battery terminals.
pp. 6–9
p. 9
p. 9
No sound comes from
the speaker. • Volume level is too low.
• An external speaker or a cloning
cable is connected to the [SP]
jack.
• Rotate [VOL] to adjust to the volume
level.
• Check the external speaker connection
or remove the cloning cable.
–
–
Transmitting is impos-
sible. • The battery is exhausted.
• Transmission is inhibited.
• The Lockout function is activated.
• Charge the battery pack, or replace the
batteries.
• Set the 'TX permission' item to “ON” in the
Set mode.
• Turn OFF the Lockout function.
pp. 6–9
p. 39
p. 20
Transmitting using the
VOX function is impos-
sible. • The VOX gain is set to OFF or too low.
• The microphone gain is too low.
• Transmission is inhibited.
• Set the VOX gain to a suitable level.
• Set the microphone gain to a suitable
level.
• Set the 'TX permission' item to “ON” in the
Set mode.
p. 50
p. 39
p. 39
No direct contact pos-
sible with other stations. • A different tone or code is used for
the tone or DTCS squelch.
• Check the tone or DTCS code by the
tone scan.
p. 32
Frequency cannot be
set. • The Key Lock function is activat-
ed.
• The memory mode, Call channel
mode, or weather channel mode*
is selected.
• Push [FUNC](
M
) , and then hold down
[ ] (# ENT) for 1 second to cancel the
Key Lock function.
• Push [VFO/MR/CALL] several times to
select the VFO mode.
–
–
A programmed scan
does not start. • The memory mode, Call channel
mode, or weather channel mode*
is selected.
• The same frequency has been pro-
grammed in the scan edge chan-
nels, “XA”–“Xb.”
• Push [VFO/MR/CALL] several times to
select the VFO mode.
• Program different frequencies as the
scan edge channels.
–
p. 27
A memory scan does
not start. • The memory mode is not select-
ed.
• Only one or no memory channel
has been programmed.
• Push [VFO/MR/CALL] several times to
select the memory mode.
• Program 2 or more memory channels.
p. 15
p. 25
The function display
shows erroneous infor-
mation. • The CPU is malfunctioning.
• External factors have caused a
fault.
• Reset the CPU.
• Remove and re-attach the battery pack
or case.
p. 46
p. 1
TROUBLE SHOOTING
13
*For only USA version of IC-V80.