1
■
Antenna
Insert the antenna into the antenna connector and twist
the antenna base to lock it in place.
CAUTION:
•
NEVER HOLD
just the antenna when carrying the
transceiver.
• Transmitting without an antenna will damage the
transceiver.
■
Belt clip
To attach the belt clip:
➥
Slide the belt clip in the direction of the arrow until the
belt clip locks in place, and makes a ‘click’ sound.
To detach the belt clip:
q
Remove the battery pack or case from the transceiv-
er, if it is attached.
w
Lift the tab up (
q
), and slide the belt clip in the direc-
tion of the arrow (
w
).
■
Battery pack or case
To attach the battery pack or case:
q
Fit the battery pack or case in the direction of the ar-
row (
q
), then close.
w
Hook the latch until it makes a ‘click’ sound (
w
).
To remove the battery pack or case:
R
WARNING!
The latch is tightly locked, so use caution
when releasing it.
DO NOT
use your fi ngernail. Use the
edge of a coin or screwdriver tip to carefully release it.
➥
Unhook the latch (
z
), and then lift up the battery
pack or case in the direction of the arrow (
x
).
CAUTION:
NEVER
remove or attach the battery
pack or case when the transceiver is wet or soiled.
This may result in water or dust getting into the trans-
ceiver or the battery pack or case, and may result in
them being damaged.
NOTE:
Keep
battery terminals clean. It’s a good idea
to occasionally clean them.
■
Jack cover
Attach the jack cover when optional equipment is not
used.
Belt clip
Battery pack/case
q
w
To attach the jack cover
q
Attach the jack cover to
the [SP MIC] jack.
w
Insert and tighten the
screws.
To detach the jack cover
z
Remove the screws
with a phillips screw-
driver.
x
Detach the jack cover to
connect optional equip-
ment.
w
q
Latch
Battery pack/case
z
x
w
w
q
z
z
x
ACCESSORIES
1
