35
■
Monitoring a DTMF memory
You can monitor the programmed DTMF code sequence.
q
Push
[FUNC](
M
)
, and then push
[DTMF-M](0)
to en-
ter the DTMF memory mode.
w
Push
[
Y
]
or
[
Z
]
to select the desired DTMF memory
channel.
e
Push
[MONI]
to monitor the DTMF memory con-
tents.
•
The programmed DTMF code sequence sounds, and
then the transceiver automatically exits the DTMF memo-
ry mode.
■
Setting DTMF transfer speed
The transmitting speed of DTMF code can be set to ac-
commodate your operating needs.
q
Hold down
[ ]
for 1 second to turn OFF the power.
w
While holding down
[
Y
]
and
[
Z
]
, hold down
[ ]
for
1 second, to turn ON the power to enter the Initial Set
mode.
e
Push
[
Y
]
or
[
Z
]
to select the DTMF TX speed item
(dtd).
r
Rotate
[VOL]
to select the desired transmitting
speed, as shown below.
• “dtd. 1”
: 100 milliseconds interval; 5.0 cps rate
• “dtd. 2”
: 200 milliseconds interval; 2.5 cps rate
• “dtd. 3”
: 300 milliseconds interval; 1.6 cps rate
• “dtd. 5”
: 500 milliseconds interval; 1.0 cps rate
(cps=characters per second)
t
Push
[# ENT]
to exit the Initial Set mode.
Push , and then push .
(DTMF memory mode)
Push
[MONI]
.
Push or to select DTMF memory channel “d3.”
[i.e.]: Monitoring DTMF memory channel “d3.”
The DTMF code sequence sounds.
Beep
Beep
Beep
• The “DTMF TX speed” item in the Initial Set mode
(“3” is selected.)
9
DTMF MEMORY
