46
RESETTING
12
■
Resetting
The LCD may occasionally display erroneous informa-
tion (e.g. when fi rst applying power). This may be caused
externally by static electricity or by other factors.
If this problem occurs, turn power OFF. After waiting a
few seconds, turn power ON again. If the problem per-
sists, perform either or both of procedures below.
D
Partial reset
If you want to reset the operating conditions (VFO fre-
quency, VFO settings, and Set modes contents) without
clearing the memory contents, do a partial reset.
q
Hold down
[ ]
for 1 second to turn OFF the power.
w
While holding down
[VFO/MR/CALL]
, hold down
[ ]
for 1 second to turn ON the power.
D
All reset
The all reset clears all programming and returns all set-
tings to their factory defaults.
q
Hold down
[ ]
for 1 second to turn OFF the power.
w
While holding down
[MONI]
and
[VFO/MR/CALL]
,
hold down
[ ]
for 1 second to turn ON the power.
• “CLEAR” appears when the transceiver is totally reset.
CAUTION:
The all reset returns all programmed con-
tents to their default settings.
