![background image](http://html2.mh-extra.com/html/icom/ic-m602/ic-m602_instruction-manual_5210088060.webp)
10
TROUBLESHOOTING
54
PROBLEM
POSSIBLE CAUSE
SOLUTION
REF.
No power comes ON.
• Bad connection to the power supply.
• Check the connection to the transceiver.
p. 49
No sound comes from
the speaker.
• Squelch level is too deep.
• Volume level is too low.
• Speaker has been exposed to water.
• Internal speaker is turned OFF.
• Set squelch to the threshold point.
• Set [VOL] to a suitable level.
• Drain water from the speaker.
• Turn the internal speaker ON in set mode.
p. 10
p. 10
—
p. 46
Transmitting is impossi-
ble, or high power can-
not be selected.
• Some channels are for low power or re-
ceive only.
• The output power is set to low.
• Change channels.
• Push [H/L] to select high power.
pgs.
8, 55
p. 10
Scan does not start.
• “TAG” channel is not programmed.
• Set the desired channels as “TAG” chan-
nels.
p. 17
No beep sounds.
• Beep tone is turned OFF.
• The squelch is open.
• Turn the beep tone ON in set mode.
• Set squelch to the threshold point.
p. 46
p. 10
Receive signal cannot
be understood.
• Optional voice scrambler is turned OFF.
• Scramble code is not set correctly.
• Turn the optional voice scrambler ON.
• Reset the scramble code.
p. 13
p. 47
Sensitivity is low.
• The attenuator is activated.
• Push [F], then [6
LO/DX
] to turn the function OFF.
p. 10
Distress call cannot be
transmitted.
• MMSI (DSC self ID) code is not pro-
grammed.
• Program the MMSI (DSC self ID) code.
p. 18