Follow the case and cover opening procedures
shown here when you want to install an optional unit
or adjust the internal units, etc.
q
Remove the 5 screws from the top of the trans-
ceiver and the 4 screws from the sides, then lift
up the top cover.
w
Turn the transceiver upside down.
e
Remove the 5 screws from the bottom of the
transceiver, then lift up the bottom cover.
CAUTION:
DISCONNECT the DC power cable
from the transceiver before performing any work
on the transceiver. Otherwise, there is a danger
of electric shock and/or equipment damage.
Disconnect the
speaker cable.
71
11
OPTION INSTALLATIONS
n
Opening the transceiver’s case
The UT-102 announces the accessed readout’s fre-
quency, mode, etc. (S-meter level can also be an-
nounced—p. 69) in a clear, electronically-generated
voice, in English (or Japanese).
➥
Push [SPCH] to announce the frequency, etc.
q
Remove the bottom cover as shown above.
• Remove the UX-910 if you have installed it. (p. 73)
w
Remove the protective paper attached to the bot-
tom of the UT-102 to expose the adhesive strip.
e
Plug UT-102 into J1801 on the MAIN unit as shown
in the diagram at right.
r
Return the bottom cover to its original position.
t
Set the speech level, announcement language and
S-meter announcement in the speech set mode
(p. 69) if desired.
UT-102
MAIN unit
J1801
n
UT-102
VOICE SYNTHESIZER UNIT
D
Opening the PA unit cover
q
Remove the 8 screws and grounding plate from the
PA unit cover.
w
Remove fastening tape from the inside power
cable.
grounding plate
e
Slide the PA unit cover as shown below.
Summary of Contents for IC-910H
Page 1: ...INSTRUCTION MANUAL VHF UHF ALL MODE TRANSCEIVER i910H ...
Page 86: ...84 MEMO ...
Page 87: ...85 MEMO ...