![background image](http://html.mh-extra.com/html/icom/ic-2100h/ic-2100h_instruction-manual_612006060.webp)
56
14
OTHER FUNCTIONS
■
Auto power-off
The auto power-off function conveniently turns the transceiver
power OFF after a preset time in which no operations are per-
formed. In this way, if you forget to turn power OFF, the trans-
ceiver automatically turns itself OFF.
The time can be set to 30 min., 1 hr., 2 hr. or turned OFF. The
selected time is retained even when the transceiver is turned
OFF via the auto power-off function. To cancel the function,
select “OF” in step
➃
below.
➀
Push [PWR] to turn power OFF.
➁
While pushing [SET], turn power ON to enter initial set
mode.
➂
Push [SET] one or more times until “POF” appears.
• Pushing [MONI] reverses the order of selection.
➃
Rotate the tuning dial to se-
lect the desired auto power-
off time or turn the timer
OFF (“OF”).
• “AO” appears when an auto
power-off time is set.
➄
Push [PWR] to exit initial set mode.
USING
INITIAL SET MODE
The display shows that the
30 min. timer is selected.
AO
■
Squelch delay
During operation, received signal strength often fluctuates.
This can result in annoying repeated opening and closing of
the squelch during reception of the same signal. The IC-
2100H has a built-in squelch delay function which helps pre-
vent this. When both stations are operating from a fixed
location e.g. during packet operation, this function should be
set to “short.”
➀
Push [PWR] to turn power OFF.
➁
While pushing [SET], turn power ON to enter initial set
mode.
➂
Push [SET] one or more times until “SQT” appears.
• Pushing [MONI] reverses the order of selection.
➃
Rotate the tuning dial to set the squelch delay to “L” (long)
or “S” (short).
➄
Push [PWR] to exit initial set mode.
USING
INITIAL SET MODE