![background image](http://html.mh-extra.com/html/icom/ic-2100h/ic-2100h_instruction-manual_612006049.webp)
45
11
DTMF MEMORY ENCODER
■
DTMF speed
The rate at which DTMF memories send individual DTMF
characters can be set to accommodate operating needs.
➀
Push [PWR] to turn power OFF.
➁
While pushing [SET] (far left switch), push [PWR] for 1 sec.
to turn power ON and enter initial set mode.
➂
Push [SET] or [MONI] to select the “DTD” display as shown
above.
➃
Rotate the tuning dial to select the desired speed as shown
in the table below.
➄
Push [PWR] to exit initial set mode.
DISPLAY
INTERVAL
SPEED
DTD-- 1
100 msec.
5.0 cps
DTD-- 2
200 msec.
2.5 cps
DTD-- 3
300 msec.
1.6 cps
DTD-- 5
500 msec.
1.0 cps
USING
INITIAL SET MODE
The display shows the
fastest DTMF speed is se-
lected.
■
Transmitting a DTMF code
D
Automatic transmission (DTMF memory)
Ä
Push [FUNC] then [
➅
DTMF] to turn the DTMF
memory function ON.
• “d” appears in place of the 100 MHz digit.
Å
Push [
F
SET] to enter the programming condi-
tion.
Ç
Push [
Y
] or [
Z
] to select the desired channel.
É
Push [PTT] to transmit the selected memory.
• Each push of [PTT] transmits the DTMF code.
Ñ
Push [
E
CLR] to cancel the function.
D
Transmitting a DTMF memory directly
Ä
Push [FUNC] then [
➅
DTMF] to turn the DTMF
memory encoder ON.
• “d” appears in place of the 100 MHz digit.
Å
Push [DTMF-S], then push the desired DTMF
channel number.
• “0” to “9” and “A” to “D” are available for channel
numbers.
Ç
Push [DTMF-S] again to deactivate the DTMF
setting.
É
Push [
E
CLR] to turn the DTMF memory en-
coder OFF.
• When the DTMF memory encoder is turned ON con-
tinuously, each push of the PTT transmits the previ-
ously selected DTMF code.
DTMF
6
DTMF S
cps=characters/sec