Installation
Installation of ceramic
Connect the Angle-valve at the Shut-off valve.
Insert the flange-packing into the flange.
flange-packing
flange
Turn the ceramic over. Place the flange at the bottom of ceramic and insert
the bolts assemble the flange and ceramic with packing nuts.
Lift up the ceramic and fix the flange at a drain.
Set the ceramic at level not to lean when
fixing the flange.
• Ceramic is heavy.
Recommend 2 workers when lifting up the ceramic.
flange
Drain
Bolts
Wax seal
Flange
or
11
16
10.
Hand-tighten 1/2” supply hose to angle stop. Use a wrench to tighten fully. Ensure
supply hose is not kinked or awkwardly bent. The hose should appear as in the picture
below.
11.
Turn on water and check for leaks.
12.
Plug unit into Ground Fault Circuit Interruption receptacle (GFCI) (required, not
included).
14.
Installation complete! Enjoy your new integrated bidet toilet!
13.
To test the water spray functions, place your hand on the seat where the sensor is
located and press either FRONT WASH or REAR WASH. You should have another person
present to cover the nozzle while testing, as the nozzle will spray water if operational.
10
12
