Icera S-20 RF, Instruction Manual

Page: 10 / 25

9
Funcons & Operaon
The nozzle system is both sanitary and effecve. The self-cleaning nozzle has separate secons for the front and rear
wash cycles. It is internally treated with an anbacterial nano-silver compound for added sterility. The nozzle is
automacally sanzed before and aer each use.
The nozzle should also be cleaned manually periodically. Using the control panel located on the seat, press the
REAR WASH and FRONT WASH buƒons at the same me. Clean the nozzle manually with a so brush.
Press the STOP buƒon on the control panel to return the nozzle to its resng posion. The self-cleaning funcon
will then operate.
The seat temperature will automacally lower when set to the highest se†ng if the seat is occupied for more than 30
minutes to protect the user against low-grade burns.
Burn Protecon
Nozzle Cleaning
09
User Presets
SAVING USER PRESETS: Set water pressure and temperature, nozzle posion, dryer temperature and seat temperature
to the desired se†ngs, then hold the buƒon for 4 seconds to save. A long beep will sound once the se†ngs are saved.
Repeat for .
ACTIVATING USER PRESETS:
Quickly press and release the user preset desired to acvate. A short beep will sound
when the user preset is acvated.
STANDARD: In Standard mode, the seat temperature will be maintained at the se†ng last selected by the user.
AUTO: Press the POWER MODE buƒon on the seat control panel to acvate the AUTO power saving mode. In
AUTO power saving mode, the seat temperature will be maintained at 86° F (30° C). Once occupied, the seat
temperature is fully adjustable via the remote control.
ECO: For even greater energy-efficiency, press the POWER MODE buƒon on the seat control panel twice to
acvate the ECO power saving mode. In ECO power saving mode, the seat will be maintained at room temperature.
When a light is turned on in the bathroom, the seat will switch to AUTO power saving mode and revert back to ECO
power saving mode when the light is no longer detected.
Power Saving Modes Power Saving Modes
Power On/Off
To turn the unit off, hold the POWER MODE buƒon on the seat panel for 4 seconds (unl the LED lights shut off).
To turn the unit on, press any buƒon on the remote except the water, dryer and nozzle adjustment buƒons.
Power On/Off
In the event of a power outage or failure, the temp. and pressure se†ngs will default to the last used se†ngs when the
seat is powered on again.