iCanView240/250 User’s Guide
Alarm
Out
Device
Relay1
Power
Supply
(
1
~30
VDC/AC,1A
)
Relay1
+
-
Relay Switch Power Supply
1V~30VDC/AC,1A
Optional
Relay Switch
Alarm
Out
Device
Power
Supply(
30V
~
)
Relay
Fig. 6-5 Connection of Relay to iCanView240/250
switch), it can also drive heavier loads.
30V AC/DC at 1A. By connecting additionally relay circuitry (such as optional relay
You can use the supported relay output to directly drive a maximum load of
6.2. Trouble Shooting
1. After iCanView240/250 is successfully installed.
•
iCanView240/250 in viewing mode, neither channel name nor video is display and eventually timeout
message is shown up.
Check the power and network connection of iCanView240/250.
To check if the network is properly operating, open the browser and try to connect to any server.
Example) http://www.yahoo.com
Or open the MS-DOS Prompt and type the following.
ping www.yahoo.com
Then press Enter. If you see the “
Reply from
…” message it means that the network is working properly.
To check if the iCanView240/250 is connected, open the MS-DOS Prompt and type the following.
ping [the IP of the server]
Example) ping 192.168.1.112
Rev.1.0 (Dec.2006)
53
Summary of Contents for iCanView 240
