Chapter 5 VGA Driver Installation Guide
CI7BM User’s Manual
71
Installing the Drivers for Windows NT 4.0
IMPORTANT
: You should install the Windows NT 4.0 Service Pack 3
first before installing the C&T 69000 VGA drivers. If you don't have the
Windows NT 4.0 Service Pack 3, please contact your software vendor or
download it from Microsoft's web site.
The procedures below show you how to install the C&T 69000 VGA
drivers for Windows NT 4.0.
1. Boot Windows NT 4.0.
2. Double click the
My Computer
icon.
3. Double click the
Control Panel
icon.
4. Double click the
Display" icon
.
5. Click
Change Display Type
.
6. Click
Change
.
7. Click
Have Disk
, then insert the diskette/CD containing the
C&T
69000 VGA driver for Windows NT 4.0
to the floppy disk
drive/CD-ROM drive, then type in
A:\WINNT40
(assuming drive A
is your floppy disk drive) or type in
D:\VGA\C&T\WINNT40
(assuming drive D is your CD-ROM drive), and press
Enter
.
8. Select
Chips Video Accelerator (65545/48/50/54/55 68554
69000)
, and then click
OK
.
9. Click
Yes
to copy the drivers from the floppy disk/CD to the hard
disk.
10. When copying is done, click
OK
.
11. Click
Close
.
12. Click
OK
.
13. Windows NT 4.0 will prompt you to restart computer. Click
OK
to
change the Windows NT configuration.
Summary of Contents for CI7BM
