Chapter 10 SCSI Installation Guide
102
CI7BM User’s Manual
* Setting is valid only if Multiple LUN Support is enabled.
** Settings are valid only if host adapter BIOS is enabled.
Starting SCSISelect
Follow these steps to start SCSISelect:
1. Turn on or restart your system.
During the startup process, pay careful attention to the messages that
appear on your screen.
2. When the following message appears on your screen, press the
Ctrl-A
keys simultaneously (this messages appears for only a few
seconds):
Press <Ctrl><A> for SCSISelect ™ Utility!
3.
From the menu that appears, use the
↑
and
↓
keys to move the cursor
to the option you want to select, then press
Enter
.
NOTE: If you have difficulty viewing the display, press F5 to toggle
between color and monochrome modes. (This feature may not work on all
monitors.)
Exiting SCSISelect
Follow these steps to exit SCSI
Select
:
1. Press
Esc
until a message prompts you to exit (if you changed any
settings, you are prompted to save the changes before you exit).
2. At the prompt, select
Yes
to exit, then press any key to reboot the
computer. Any changes you made in SCSI
Select
take effect after the
computer boots.
Using SCSISelect Settings
To select an option, use the
↑
and
↓
keys to move the cursor to the option
you want to select, then press
Enter
.
In some cases, selecting an option displays another menu. You can return
to the previous menu at any time by pressing
Esc
.
To restore the original SCSI
Select
default values, press
F6
from the main
SCSI
Select
screen.
Summary of Contents for CI7BM
