IBM x3100 M5 Type 5457, Installation And Service Manual

Page: 333 / 688

Replacing the system board
Use this information to replace the system board.
Note:
1. When you reassemble the components in the server, be sure to route all cables
carefully so that they are not exposed to excessive pressure.
2. When you replace the system board, you must either update the server with
the latest firmware or restore the pre-existing firmware that the customer
provides on a diskette or CD image. The vital product data (VPD) must also be
updated. Make sure that you have the latest firmware or a copy of the
pre-existing firmware before you proceed. See “Updating the firmware” on
page 93 and (see “Updating the DMI/SMBIOS data” on page 116) for more
information.
Attention: Installing the wrong firmware or device-driver update might cause
the server to malfunction. Before you install a firmware or device-driver
update, read any readme and change history files that are provided with the
downloaded update. These files contain important information about the
update and the procedure for installing the update, including any special
procedure for updating from an early firmware or device-driver version to the
latest version.
3. Reactivate any Features on Demand features. Instructions for automating the
activation of features and installing activation keys is in the IBM System x
Features on Demand User’s Guide. To download the document, go to
/http://www.ibm.com/systems/x/fod/, log in, and click
Help .
Important: Some cluster solutions require specific code levels or coordinated code
updates. If the device is part of a cluster solution, verify that the latest level of
code is supported for the cluster solution before you update the code
To install the system board on the 4U server model with non-hot-swap power
supplies, complete the following steps. For 5U server models with hot-swap power
supplies, please see the next sub-section.
1. Read the safety information in “Safety” on page vii and “Installation
guidelines” on page 35.
2. Pull the hard disk drive cage half out of the chassis.
Chapter 6. Removing and replacing components
317