IBM WebSphere DataPower 7198, Installation And User Manual

Page: 79 / 88

v
Unplug all power cords.
v
Pull downward on the blue latch on the front of the transceiver, as shown in
Figure 28.
v
Pull the transceiver out by pulling forward the blue latch.
Removing the appliance from the rack
Generally, after installing the appliance in the rack, you need to remove it only to
move it to another position in the rack.
CAUTION:
Type 7198: This part or unit is heavy but has a weight smaller than 18 kg (39.7
lb). Use care when lifting, removing, or installing this part or unit. (C008)
CAUTION:
Type 7199: The weight of this part or unit is between 18 and 32 kg (39.7 and 70.5
lb). It takes two persons to safely lift this part or unit. (C009)
> 18 kg (39.7 lb)
To remove the appliance from the rack:
Note: Make sure two people lift the appliance, with hands positioned as illustrated
by
2
in Figure 29 on page 60.
1. Unlatch and rotate the front of the appliance, as shown in Figure 29 on page 60.
a. If the appliance is not turned off, press the power button on the front of the
chassis. The power LED should not be illuminated.
b. Unplug all power cords.
c. Pull the locking levers
1
forward. With two people supporting the front
and the rear of the appliance
2
, lift the front of the appliance up slightly
3
to clear the nailhead from the slot.
A
Figure 28. Removing the SFP transceiver
Chapter 7. Removing or replacing the appliance or parts
59