IBM WebSphere DataPower 7198, Installation And User Manual

Page: 38 / 88

2. Install the rear end of the slide rails, as shown in Figure 10:
a. From the front of the rack, line up the three pins on the rear of the slide rail
with the three holes in the selected U on the rear of the rack.
b. Push the rails so that the pins go into the holes
1
, and latch down into
place
2
until it latches into place.
Notes:
1) If you are installing the slide rails into a 1U space with devices already
installed directly above and below this 1U space, you will need to
extend the slide rails to slide the rear of the slide rails into the rear of
the rack. When you install a 2U appliance, be sure to install the slide
rails in the bottom of the 2U area in the rack.
3. Install the front end of the slide rails, as shown in Figure 11 on page 19.
a.
Pull the slide rail forward and insert the two pins
1
on the front of the
rail into the two lower holes in the U on the front of the rack.
b. Drop the rail into place until it clicks. Push the front latch
2
in all the
way.
L
3
Figure 9. View of the slide rails
Rear Rack
Figure 10. Install the rear end of the slide rails
18
Installation and User's Guide