IBM Tape Library Magstar 3494, Operator'S Manual

Page: 169 / 378

Specific Media Type
Select this checkbox if the list output should only include volumes of a
certain media type. Use the associated drop-down list to select which media
type to limit the output to. The media type describes the physical
characteristics of the cartridge as well as the logical library the volume is
associated with. The library sequence number is shown next to each media
type (xxxxx). Some or all of the following selections are available based on
the number and type of logical libraries:
v
1 - CST (Non-VTS xxxxx)
v
E - ECCST (Non-VTS xxxxx)
v
J - HPCT (Non-VTS xxxxx)
v
1 - CST (VTS 1 xxxxx)
v
E - ECCST (VTS 1 xxxxx)
v
J - HPCT (VTS 1 xxxxx)
v
1 - CST (VTS 2 xxxxx)
v
E - ECCST (VTS 2 xxxxx)
v
J - HPCT (VTS 2 xxxxx)
Specific Category
Select this checkbox if the list output should only include volumes with a
specific category. Use the associated entry field to enter the desired
category. The category must be entered as a 4 digit hexidecimal number.
Volser Mask
Select this checkbox if the list output should only include volumes that
match the volser mask. Use the associated entry field to enter the 1 to 6
character volser mask. You can include a wildcard (pattern-matching)
character, where ? or _ indicates one character and * or % indicates
multiple characters.
Flags Select the desired flag radio buttons if the list should only include volumes
with certain flags set or cleared. Each flag can be set to 1 of 3 possible
settings by clicking on the associated radio button.
The flags can be:
v
Yes
The flag’s condition applies to this volume (list volumes that this flag
applies to).
v
No
The flag’s condition does not apply to this volume (list volumes that this
flag does not apply to).
v
Ignore
List volumes with the flags set to any value (list volumes without regard
to the state of the flag).
The following flags can be selected:
v
Misplaced
v
Unreadable
v
Mounted
v
Inaccessible
v
Manual Mode
Chapter 6. Advanced Operating Procedures
147